Layer 6 problem
|
Layer 6 problem
|
03-02-2007, 03:20 AM
If you turn off fringe drawing in layer six, you can copy individual pieces of fringe from place to place with the copy tool. It's not a perfect solution, but it would look slightly better. The problem is that there isn't a single tile with two different brick colors in it. Normally, the tile fringe gets put in layers one through three, so they can lie on top of each other, but layer six has no way of doing that.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Layer 6 problem - by frost - 03-02-2007, 12:52 AM
Re: Layer 6 problem - by Psychotronic - 03-02-2007, 03:20 AM
Re: Layer 6 problem - by frost - 03-02-2007, 07:00 PM
Re: Layer 6 problem - by Psychotronic - 03-02-2007, 09:23 PM
Re: Layer 6 problem - by Mikee - 03-02-2007, 09:43 PM
Re: Layer 6 problem - by aquaMat - 03-03-2007, 04:58 PM
Re: Layer 6 problem - by frost - 03-13-2007, 07:37 PM
Re: Layer 6 problem - by Psychotronic - 03-13-2007, 07:57 PM
Re: Layer 6 problem - by frost - 03-14-2007, 09:52 PM
Re: Layer 6 problem - by Psychotronic - 03-14-2007, 10:09 PM
Re: Layer 6 problem - by frost - 03-15-2007, 02:22 AM
Re: Layer 6 problem - by Psychotronic - 03-15-2007, 08:45 AM
Re: Layer 6 problem - by frost - 03-16-2007, 04:10 AM
Re: Layer 6 problem - by Psychotronic - 03-16-2007, 07:10 PM
Re: Layer 6 problem - by joeb - 03-16-2007, 10:23 PM
Re: Layer 6 problem - by Wingy - 03-16-2007, 11:13 PM
Re: Layer 6 problem - by VernJensen - 04-17-2007, 02:38 AM
Re: Layer 6 problem - by Freddy - 04-18-2007, 06:05 PM
|
